As we all know, when it comes to installation and use, installation and use of the work environment is a must. So, the milling machine needs to be installed in what kind of working environment? Let's get to know the following:

1, to meet the requirements of the milling machine equipment into the surface flat wood floor, the slope on both sides should be lower than 10 degrees, and the wood floor should be strong, the load capacity should be more than 150% of the milling machine's own weight, but also need to prevent the milling machine equipment located in smoke, moisture, corrosion stimulation vapor, corrosion stimulation liquid, high intensity radioactive substances, high intensity vibration working environment. The milling machine equipment also needs to be surrounded by sufficient manufacturing control space in advance.

2, the working voltage to meet the requirements of the requirements of the working voltage of the milling machine, such as the milling machine is 380v AC circuit, the working voltage in fact accurate measurement value should be within 380±5%, if there is constant fluctuation of the working voltage should grasp the adjustable voltage regulator power supply equipment. The use of cable specifications should be in the total output power of the milling machine basically retained 10% in advance, the cable should choose the three-phase four-wire system, grasp the neutral point and grasp the necessary conditions for sufficient grounding device, the distribution line should grasp the leakage protection switch equipment, cable specifications according to the connection spacing moderate increase.

3. After the milling machine is put into the surface flat, it is also necessary to trim the cross sliding table level, put the level into the clean and tidy cross sliding table, trim the bottom end of the milling machine adjustment pad iron, so that the cabinet table in the horizontal and vertical level deviation in 0.04/100mm.

4. After adjusting the working table, install the dressing screw into the screw hole of the base of the milling machine, and then put the adjusting pad iron on the wood floor below the dressing screw, and match with the dressing screw.

5. The installation and use of cable distribution line should be carried out by professional and technical personnel with professional electrical knowledge. The terminal nerve of cable line should be installed and used in accordance with the type and specification of cold shrinkage cable terminal nerve connector (copper wire nose). The cable terminal nerve is installed and used in the milling machine distribution cabinet on the pre-reserved four terminal block, in which the pure color line is three-phase 220V AC power supply system, the two-color line is the ground line, and then clamp.